How to add water to a garment steamer

There is a water storage tank below, you can add water when you open the water inlet, add tap water as much as possible, do not add mineral water. Try not to be short of water. Although there are protection measures such as temperature control inside, it is still necessary to avoid dry burning of the empty machine. Be sure to unplug the power cord when not in use to prevent danger. If the handle is broken or the nozzle leaks, replace it at any time; do not touch the steam nozzle before cooling to avoid burns.​​

1. Take out the water tank, open the water tank filling valve, and tighten the water valve after adding water (cold water must be added).

2. Grab the handle of the water tank, put it on the main body, and turn on the power. Press the power switch of the machine, and switch the power switch to "Ⅰ" or "Ⅱ" gear, and the power indicator light is on, indicating that the whole machine is powered on at this time, and the clothes dryer has entered the working state.

3. After about 45 seconds (note: in winter, if the temperature is too low, the steam output time will be longer) and start to spray steam. At this time, hang the clothes (except leather clothes) and iron them. .

4. If you want to remove the dust and debris from the clothes during this process, you need to install the brush (installation method: align the buckles at both ends of the brush with the round holes of the steam nozzle, press the brush towards the steam nozzle, Until the sleeve is inserted. Please do not install the brush in a hot state when using it to avoid burns).

5. If you want to iron straight trousers line, you can install the trousers seam clip (align the hole in the middle of the trousers seam clip with the pin of the nozzle in place, press the end of the trousers seam clip with your hand, and the front end can be opened, then install it. All right.

6. In addition to ironing clothes, it can also sterilize baby's toys, and can also be used as a humidifier in a fixed place.

7. After finishing the work, turn the power switch to the "0" position and pull the plug out of the socket.